OBS bitrate calculator for Twitch, YouTube and Kick
Bitrate, resolution, FPS and encoder preset for your upload speed, with values for Twitch, YouTube and Kick.
Open →Set up the timer, copy the link and add it to OBS as a Browser source. The background is transparent, so viewers see only the numbers and your text. No account needed.
To change the look later, set up a new timer and replace the link in the source properties. You don't need to delete the source.
The countdown and the stopwatch start when OBS loads the source: when you add it, when OBS starts and when you refresh the source. To start over during a stream, open the source properties and click Refresh cache of current page.
The countdown to a set time uses the clock of the PC that runs OBS. Set 12:15 AM at 11:30 PM and the timer shows 45 minutes.
Everything the timer needs is in the link. There is no account, nothing is stored on a server, and the page makes no requests after it loads.
Set up the timer on this page and copy the link. In OBS, add a Browser source, paste the link into URL and set the width and height shown under the link. The timer appears on the scene with a transparent background.
No, as long as Refresh browser when scene becomes active is off in the source properties. It is off by default. If you turn it on, the countdown starts over every time the scene opens.
No, this is a simple timer without controls during the stream. A subathon timer that adds time for subs and donations needs a service connected to your alerts. To change the time here, make a new link and replace it in the source.
Yes, in any streaming app with a browser source: Streamlabs Desktop, XSplit, Meld Studio and others. Paste the same link and set the same size.
Turn on Sound at the end and the timer plays three short beeps at zero. To control the volume in the OBS mixer, tick Control audio via OBS in the source properties.
Bitrate, resolution, FPS and encoder preset for your upload speed, with values for Twitch, YouTube and Kick.
Open →Check mic levels, clipping and room noise, record 10 seconds and get starting points for OBS filters.
Open →Left, right and both channels, a swap check and a 20 Hz to 20 kHz sweep, starting at a safe volume.
Open →